Progressing with wing bottom skins
Posted On October 3, 2018
Continuing with fitting bottom skins, and elongating holes where needed to fit properly on the spar cap.
I’m using a round file to remove most of the needed material, and then using a #20 reamer to clean up the hole and ensure it’s roundish. So far so good – I’ll do this to both bottom skins before I start pulling the rivets.
![](https://i0.wp.com/sling4.jetshine.net/wp-content/uploads/2018/10/img_1074-e1538536582844-1024x406.jpg?resize=525%2C208&ssl=1)
![](https://i0.wp.com/sling4.jetshine.net/wp-content/uploads/2018/10/img_1075.jpg?resize=525%2C394&ssl=1)